MISC Bosch Miscellaneous - Instructions

After researching YouTube, I figured out the problem was the left side of the door was dropping. Took some screws out where the dishwasher was attached to the counter and cabinets. It took a bit to pull the dishwasher out but when done, the fix was easy. Reverse the process, make sure there’s power and hoses are back.

Unplug the power cord, remove and clean out drain hose. Remove back access panel. Unplug wiring harness, remove both drain hoses from old pump. Have a wet/dry shop vac ready and running to help avoid a mess. Reconnect both drain hoses and wiring harness to new pump and replace back access panel. Do laundry.

When putting on the new spring clamp it will come out unless you take a few clamps to hold it in place.

The instructions stated to remove the door. I spent an hour attempting to remove the door. That was an unnecessary instruction. all else worked as described. Springs were easy to install. The attachment to the door was difficult. Better instructions on how to grasp the connection to spread the spring to give the cable enough slack to attach the connection to the door.

Pulled out the old piece after removing turntable and put new piece in. Then put turntable back on top.
It's a $9 part and I probably saved at least $200.

The spray arm makes a slide in attachment to a slide out drawer. It was removed by forcing out of the connection on the back of the drawer and the replacement was installed by sliding it into the same connection point.

The new rack arrived nearly ready to install. The brackets and wheels that connect the rack to the track in the dishwasher were already on the new rack when it was delivered. All I had to do was move some plastic parts from the old rack to the new rack. This is very easy and does not require any tools since the parts snap onto the racks. It's worth taking a moment to study the way each part is attached to the old rack before moving it to the new rack. Pay particular attention to exactly how & where the spray arm tube snaps to the rack. That tube took me two tries to get right. The whole operation took less than 15 minutes.

Repair was simple once the problem was diagnosed with the inlet valve.
Most of the work was in disconnecting the necessary lines so the dishwasher could be removed from the cabinets to replace the bad valve. Replacing the valve was easy. Reinstalling the dishwasher was just the reverse of the removal. The replacement part matched the original and solved the problem we had.

Easily removed the old one by carefully pulling it and repeated this procedure to replace it. Total time took less than 15 minutes

Look up how to repair on you tube. Removed control panel door and front panel as shown to expose water pump. Removed both hose. Showed how to release water pump from under machine ( I use vibrating cutter to cut rubber feet that held in place) this was much easier than way shown in video. Caution when putting hose clamp Bach on make sure it is all the way on. If not you will have water leak drain hose come off. But panels on . Be careful not to damage door lock 124 dollars if you do. Over all very easy to replace

followed video on computer. direction that came with part could not follow, and i have 50 yrs. of blueprint work.

we watched a thorough you tube video which described each step and showed it being done, he made it look pretty easy but unforeseen elements such as rust etc took time but not obscenely so, just keep screws from each step separate and it's difficult just takes patience and a little time to get to the actual part, in fact that is the easy part taking it out and replacing it.

Part arrived on time. Double checked it was the part I needed. I unclipped the old seal and snapped the new piece in place.

Unscrewed the old piece screwed in the new

After going to a local parts store to get the correct switch, I replaced the right door switch. The correct switch is a normally open switch. The one shipped to me was a normally closed switch. Either Bosch provided the wrong description of the part required or someone at partselect needs to check the part stocked.