Models > KOCE500ESS02 > Instructions

KOCE500ESS02 KitchenAid Microwave - Instructions

Jump to:

All Instructions for the KOCE500ESS02
31 - 45 of 64
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Elena from HOUSTON, TX
Parts Used:
W11724411
Difficulty Level:
Very Difficult
Total Repair Time:
Less than 15 mins
Part broken
We ordered element support 3 times and all three times it came broken. The part is made of porcelain and is fragile , representative asked warehouse to pack it in the box and part still came in envelope.
Requested refund and ordered directly from factory.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Andrew from LAKEVILLE, MN
Parts Used:
W11724411
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Grill support broke. Sounds like a common problem based on other’s comment.
Turn the grill support 90 degrees to the opening in ceiling of micro. Insert then turn back 90 degrees so the support is in-line with the slot. Hang the wire on the support. Hours of worry over what this was gonna cost me to get repaired, then a 45 second fix costing only 29 bucks.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joyce from Conyers, GA
Parts Used:
W11724411
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
The ceramic hanger that holds up the element for the convection over broke
Took about 10 seconds... turn the new ceramic holder sideways, push up in the hole, bring the element up to position and twist the ceramic piece 45 degrees into place to hold element. That's it!!! Very simple....
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
William from Carbondale, CO
Parts Used:
WP4449751
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
upper oven of wall oven would not heat suspected high temp limit switch
removed unit from cabinet tested switch it was OK checked wiring and found shorted out wire leading to switch. cut out bad section and spliced wire back together
problem solved
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kerry from Carrollton, TX
Parts Used:
W10915651
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Part worn out
Could not complete the repair due to broken part when arrived. Reached out to service department but have not heard back. Maybe email did not go through due to pictures attached of part condition once arrived.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Tom from BELLEVUE, WA
Parts Used:
W11245567, WP74008369
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers
Temperature not holding and blower squeeling
Put cribbing on a dolly, slid the oven out of the cabinet. Unfastened the upper broiler element allowing removing temperature sensor screw. Removed all the back panels and pushed the temperature sensor wire clip thru to the oven, Pushed the new emperature sensor wiring back thru the hole to the back. Removed and repalaced the blower re connected the wire harnes for the blower and temperature sensor.. Replaced all the back panels and slid the oven back into the cabinet. Re attached the temperature swensor and re fastioned the upper broiler element. All went well and am glad the sales lady sent the how to videos. The videos were foir a different model but were essentially the same.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Larry from Fernandina Beach, FL
Parts Used:
W11724411
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken mounting bracket for coils in convection microwave.
Very easy, fit perfectly.No tools required.
4 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeff from Baytown, TX
Parts Used:
W11373838
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
I broke the glass cooking tray when instaling my oven microwave combo
I put the tray in the microwave???? Pretty easy.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gary from WALTON, KY
Parts Used:
W10886919
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
INTERIOR OVEN LIGHT
EASILY REMOVED GLASS COVER INSIDE OVEN AND REMOVED SMALL HALOGEN LIGHT BULB.
RECEIVED REPLACED WITHIN TWO DAYS OF ORDER AND REPLACED BULB AND GLASS COVER IN ABOUT 10 MINUTES.
MOST DIFFICULTY WAS HAVING TO BEND DOWN TO REACH INSIDE OF OVEN TO LOCATE POSITION TO INSERT BULB.
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Raymond from HINSDALE, IL
Parts Used:
W11373838
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Old microwave glass tray shattered while warming a hard-boiled egg.
I took the new tray out of the box and placed it in the microwave oven.. No tools needed.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ed from Canyon Country, CA
Parts Used:
WP9755542
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Oven light bulb inop
Taking off the glass lense for the light bulb was harder than I thought. It unscrews counterclockwise, but it was very hard to get off. It would not turn. I ended up using connector pliers I use for work, that has rubber jaws. The lense unscrewed very easy with it. Light also unscrews out. PartSelect.com is the only way to go to buy parts for appliances. It is simple, even has the illustrated parts catalog. And it saves a lot of time and gas, driving around looking for the part!!. PartSelect came through again.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from Ladson, SC
Parts Used:
W11193483
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers
The light in our microwave was out.
We had to remove screws from the vent covers above and below the microwave, then there were 2 screws (one on each side) that attached the microwave to the oven. Once all of the screws were removed we had to pull the microwave out. Then we pulled the light cord out, removed the burnt out light and installed the new one. Then reversed the steps.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
jeff from las vegas, NV
Parts Used:
W11110134
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
replace spindle on turning table
exact part in with the new out with the old
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Navid from Dunn Loring, VA
Parts Used:
W11373838
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Microwave cooking glass broken
Easily replaced after received the product from Part Select. Very satisfied.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Janet from Concord, CA
Parts Used:
W11373838
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
broken glass dish for microwave
no repair needed - ordered part, came within 3 days - very satisfied
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the KOCE500ESS02
31 - 45 of 64