OEM Black and Decker Jig Saw Parts & Accessories

Power Cord

$17.56

Fix Number: FIX10169875
Manufacturer Part Number: 330072-98

This power cord is used for power tools and some of the following tools: electric drills, reciprocating saws, jig saws, biscuit joiners, and routers. The power cord is made for double insulated tools and is a two-wire cord with two prongs, but it does not need a ground wire. If there are cuts in the cord insulation, intermittent power during operation, or damaged and bent prongs, then replacing the power cord will solve the problem. The tools needed for this repair are a Phillips screwdriver, small screwdriver, wire cutters/strippers, crimping tool, and terminal (ring or spade). Repair tip: During installation, remember that new cord wires must go correctly into wire terminals. Also, to avoid pinching when the tool case is put back into place, remember to route cord and wires in the right path.

Installation Instructions

John from Hancock, MI

Did not come with grinding disc guard

While unit was unplugged I screwed clamp of guard around grinder. Read more...

Watch the install video

Grinder Motor Brush

$7.87

Fix Number: FIX10106782
Manufacturer Part Number: 445861-25

(Sold Individually) This motor brush is for grinders. The motor brush transfers electric current to the spinning armature in the motor. Unplug the grinder before installing this part. Wear work gloves to protect your hands.

Cord/8 FT/18-2

$20.39

Fix Number: FIX10169879
Manufacturer Part Number: 330073-98

Blade Clamp

$5.29

★★★★★

1 Review

Fix Number: FIX10180085
Manufacturer Part Number: 582593-00

The job of the blade clamp is to secure the saw blade to the shaft of the jigsaw. The blade clamp is meant to make blade changes quick and easy with its quick-release design. Over the use of your tool, the clamp will begin to wear and this will result in its inability to hold the blade properly. This blade clamp is sold individually and sourced right from the original manufacturer.

Installation Instructions

Glendale from LOS ANGELES, CA

Blade Clamp Replacement

1. Remove two (2) allen hex nut holding blade clamp to shaft.
2. Using a flathead screwdriver or plier, gently pry clamp downward away from shaft.
3. Installation is reverse. Slide new blade clamp to shaft, gently slide until hex nut holes align and insert nut and tighten down. Read more...

Brush Spring

$4.99

★★★★★

1 Review

Fix Number: FIX10173420
Manufacturer Part Number: 445860-00

This is a brush spring and it is used in a variety of power tools. The spring applies force to the motor brush inside the motor. This will keep the brush tight along the armature. If the brush has worn down it will create heat, and the spring will lose tension. If this happens, both parts will have to be replaced.

Saw Blade

$11.79

Fix Number: FIX10253438
Manufacturer Part Number: 74-591

Brush

$3.99

Fix Number: FIX10105860
Manufacturer Part Number: 089754-01

Installation Instructions

tom from TWO RIVERS, WI

motor noisey

I don't know exact cause for noise. Thought it might be brushes. Got one out; it looked ok. Repair was not possible because the second brush holder could not be removed due to interference from wiring. I would have tried to replace motor shaft bearing but part NLA. Read more...