OEM DeWALT Cordless Drill Parts & Accessories

HOUSING ASSEMBLY

$15.44

Fix Number: FIX12508695
Manufacturer Part Number: N413423

This is the housing assembly for an impact driver. This plastic casing includes the right and left side, is yellow and black in color, and has the DeWalt logo on the side. The housing is what protects in inner components of the tool. If the housing has become worn, cracked, or damaged, this is the OEM replacement part needed to fix it. For this simple repair, you will need to remove the screws holding the old housing assembly in place (screws sold separately) and remove everything out of the old case and transfer them to the new case.

Watch the install video

Brush Box (Sold Individually)

$9.49

Fix Number: FIX10180814
Manufacturer Part Number: 603754-01

The brush box assembly is used on a variety of cordless tools and appliances. This assembly includes a carbon brush, spring and holder. Carbon brushes are commonly replaced because they wear out easily with friction. If your brush is worn out it disrupt the function of the motor and reduce electric braking. Tip: to check if the brush is worn out, inspect the wire lead for cracks, burns and other damage. Replacing the brush can restore the motor and its functions. Refer to the manual provided by the manufacturer for further installation instructions. *Please note: This part is sold individually.

Watch the install video

Belt Hook

$3.99

Fix Number: FIX10189049
Manufacturer Part Number: N268241

This OEM belt hook makes it possible for drills and drill drivers to attach to a regular belt or tool belt. It attaches to the bottom of the handle assembly and makes it convenient to access your tool when it is not in use. This part includes the belt hook and screw needed to attach it.

Watch the install video

Brush & Holder Assembly

$15.60

★★★★★

1 Review

Fix Number: FIX10187386
Manufacturer Part Number: N031214

This part contains two carbon brushes and holder sets. Carbon brushes are a routine maintenance task, as they are prone to wear due friction. Worn brushes are the most common reason for a motor that is not running properly or at all. In general, this is a pretty easy repair, but keep in mind that instructions can vary slightly depending on the model. To access the brushes, you will need to remove the housing of the tool and the brushes will be located inside the holders close to the motor.