Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
Water Inlet Valve WD15X93
$57.45
In Stock
- Fix Number:
- FIX259411
- Manufacturer #:
- WD15X93
- Manufactured by:
- GE
- Product Description
- This water inlet valve is specially designed for those dishwashers that fit under the counter from 1974 To Present. The valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
- Works with the following brands:
- General Electric, Hotpoint, Kenmore, Amana
- Works with the following products
- Dishwasher
- Fixes the following symptoms
- Will not fill with water, Leaking, Not cleaning dishes properly, Not draining
- Part# WD15X93 replaces these:
- AP2039339, 3310, WD15X93, WD15X0040, WD15X0046, WD15X0050, WD15X0052, WD15X0053, WD15X0057, WD15X0059, WD15X0066, WD15X0067, WD15X0072, WD15X0073, WD15X0076, WD15X0077, WD15X0078, WD15X0079, WD15X0080, WD15X0082 ... Show more , WD15X0084, WD15X0085, WD15X0086, WD15X0087, WD15X0088, WD15X0089, WD15X0090, WD15X0091, WD15X0092, WD15X0093, WD15X0095, WD15X40, WD15X46, WD15X50, WD15X5033, WD15X5050, WD15X5052, WD15X5091, WD15X5093, WD15X5093R, WD15X52, WD15X53, WD15X57, WD15X59, WD15X66, WD15X67, WD15X72, WD15X73, WD15X76, WD15X77, WD15X78, WD15X79, WD15X80, WD15X82, WD15X84, WD15X85, WD15X86, WD15X87, WD15X88, WD15X89, WD15X90, WD15X91, WD15X92, WD15X93R, WD15X95, WD21X0127, WD21X0145, WD21X0536, WD21X127, WD21X145, WD21X536 Show less
Part Number Cross Reference
Product Description
This water inlet valve is specially designed for those dishwashers that fit under the counter from 1974 To Present. The valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
-
Works with the following brands:General Electric, Hotpoint, Kenmore, Amana
-
Works with the following products:Dishwasher
-
Fixes the following symptoms:Will not fill with water, Leaking, Not cleaning dishes properly, Not draining
-
Part# WD15X93 replaces these:AP2039339, 3310, WD15X93, WD15X0040, WD15X0046, WD15X0050 ... Show more , WD15X0052, WD15X0053, WD15X0057, WD15X0059, WD15X0066, WD15X0067, WD15X0072, WD15X0073, WD15X0076, WD15X0077, WD15X0078, WD15X0079, WD15X0080, WD15X0082, WD15X0084, WD15X0085, WD15X0086, WD15X0087, WD15X0088, WD15X0089, WD15X0090, WD15X0091, WD15X0092, WD15X0093, WD15X0095, WD15X40, WD15X46, WD15X50, WD15X5033, WD15X5050, WD15X5052, WD15X5091, WD15X5093, WD15X5093R, WD15X52, WD15X53, WD15X57, WD15X59, WD15X66, WD15X67, WD15X72, WD15X73, WD15X76, WD15X77, WD15X78, WD15X79, WD15X80, WD15X82, WD15X84, WD15X85, WD15X86, WD15X87, WD15X88, WD15X89, WD15X90, WD15X91, WD15X92, WD15X93R, WD15X95, WD21X0127, WD21X0145, WD21X0536, WD21X127, WD21X145, WD21X536 Show less
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Related Parts Additional or alternate parts to consider.
Installation Instructions Provided by Fix customers like you.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
- Customer:
- John from Vacaville, CA
- Parts Used:
- WD15X93
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers
No water to dishwasher
Pulled off front panel and ran the dishwasher through the cycle with a voltmeter hooked up to the water solenoid valve. Was getting 110, so I figured the solenoid was bad. (Had already made sure the float was free and the door switch was working). I'd changed a water valve out once before and it was pretty easy so I ordered the part and
... Read more
it arrived in a couple of days. Unplugged the cord, removed the waterline and then removed 2 screws holding the old unit. Re installation is the reverse. The only trouble I had was installing the screws. After about 10 minutes of trying to get the screws started with no success, I pulled the valve back out and realized there are no threads in the holes. The screws are self-tapping and once I ran the screws in it went together without any problems. So... Tip for those reading this, drive the screws 1/2 way into the hole before you start the installation. It makes things a lot easier. That done, I reattached the water line (which didn't exactly line up with my copper tubing because the elbow didn't point the right direction when snugged up, so I had to use a lot of Teflon tape to get it sealed.) That done, when I turned it on the water still didn't fill. My big mistake was that I checked all the electrical circuits up to the water valve but didn't realize it won't fill with water until the drain solenoid activates, and guess what? My drain solenoid was the culprit. I laid on the floor and watched the machine cycle and when the drain solenoid activated (it's right under the center of the dishwasher) I could see a little water leaking down and shorting it out. Since I'd already dropped $30 on the water valve I didn't think it was worth having to replace the solenoid valve for $50 plus whatever it would cost to replace the drain tube. It's an 18 year old dishwasher so I'm just getting a new one. That said, the Parts Select site was helpful and they're prices and shipping were fine, so don't let my situation deter you from tackling the job. My biggest tip take a good look at the dishwasher in action. Once I looked at it, the drain solenoid was covered in crud and the water valve looked fine - that should have been my first clue.
Read less
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- paul from plymouth, MN
- Parts Used:
- WD15X93
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Wrench (Adjustable), Wrench set
would not fill with water
removed base plate and upper plate just below the door. i followed your instructions. it was a little tight work area, but just had to take your time. the only problem i ran into was the bracket on the replacement part did not match the old one, so i had to make a few adjustment, got everything back together , fired it up, and she works
... Read more
like new. my advise to everyone is bring all the right tools, follow the instructions , TAKE YOUR TIME.
Read less
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Model Compatibility
This part works with the following models:
Fix Number: FIX259411
Manufacturer Part Number: WD15X93
Manufacturer Part Number: WD15X93
Brand
Model Number
Description
✖
Mail-In Recycling Rebate