Models > HMV3021U-01 > Instructions

HMV3021U-01 Bosch Range - Instructions

Jump to:

All Instructions for the HMV3021U-01
1 - 2 of 2
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
STEPHEN from SAN MATEO, CA
Parts Used:
00617229
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Fuse Blows when door is opened
Replaced fuse and switches.This is an undercabinet microwave.
The fuse is located in top right but there is no access from the front of the microwave necessitating complete removal of the microwave from the cabinets and then taking the microwave cover off.
This is a terrible design,
Instead, I cut the vent grate on the top right front of the microwave to access the fuse.
replaced the fuse.
Switches were relatively easy to replace...being careful to not pull wires out of connectors or breaking small plastic tongs and clips.
Microwave is still blowing fuses though. door alignment may be off.
Again, terrible design and lousy product quality.
7 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ALAN from RYE, NH
Parts Used:
00683851
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
Cracked front door panel
Taking the door apart is fairly easy. However, transferring the glass panel to the new door is complicated. I took an hour to figure out that the new plastic door panel must be curled and spread apart in order to get the glass in the plastic tabs that secure it.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the HMV3021U-01
1 - 2 of 2