Models > 0350040U

0350040U Cub Cadet Lawn Mower

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
Lawn Mower Washer – Part Number: 936-0119
$4.95
This lock washer is used to resist the loosening of bolted joints. Repair tip: It is difficult to install the lock washer in a tight place or when the bolt/screw is pointing down. This lock works with...
In Stock
Order within the next 9 hrs and your part ships today!
Trimmer Ball Joint – Part Number: 923-3018
$17.85
In Stock
Order within the next 9 hrs and your part ships today!
Pin, Cotter, 1/8 x 1.25 – Part Number: 914-0470
No Longer Available
Lawn Mower Screw – Part Number: 710-0347
$5.58
In Stock
Order within the next 9 hrs and your part ships today!
Lawn Mower Screw – Part Number: 710-0227
$4.99
In Stock
Order within the next 9 hrs and your part ships today!
Lawn Mower Flange Brg. W/Flats .75" I.D. – Part Number: 941-0490
$16.52
In Stock
Order within the next 9 hrs and your part ships today!
Fitting Lube 3/16 Drive Type – Part Number: 937-3000
$5.95
In Stock
Order within the next 9 hrs and your part ships today!
Lawn Mower Air Valve – Part Number: 934-0255
$5.95
In Stock
Order within the next 9 hrs and your part ships today!
Hexagonal L-Nut – Part Number: 912-0158
$5.95
In Stock
Order within the next 9 hrs and your part ships today!
Lawn Mower Clevis Pin – Part Number: 911-0332
$17.25
In Stock
Order within the next 9 hrs and your part ships today!
Engine Filter – Part Number: 298090S
$4.99
In Stock
Order within the next 9 hrs and your part ships today!
Lock Washer (7/16
$5.32
Special Order
View More

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Dana from HAMMOND, IN
Parts Used:
792006
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set
Mistreated Briggs & Stratton 206 CC Engine on MTD Chipper
Removed tank and drained old gas.
Removed and disassembled carb. Needed new gaskets and seals, and had to clean corn syrup glaze (separated ethanol) from bowl and everywhere else with carb cleaner.
Throttle linkage was de-plating/rusty. Steel wool and WD40 got it moving again.
Cleaned spark plug electrode.
Reassemble d, poured Sea Foam in the bottom of the tank and gave it a few pulls.
Let Sea Foam sit for a while, then filled the tank with Premium.
Blew white smoke for a minute then ran like new. Shredded for a while, then changed the oil.
Read less
7 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
View More