WTG86401UC (01) Bosch Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Lawrence from SARASOTA, FL
- Parts Used:
- 00145623
- Difficulty Level:
- Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Screw drivers
DR error stopped machine. Had to diagnose problem.
You tube videos use to guide me.
Cleaned it sump area. Still not work.
Guessed it was pump. 5 hours over a period of 2 weeks
Ordered pump.
Replaced it.
Problem solved.
5 or so more hours. Most of work opening side panel
Cleaned it sump area. Still not work.
Guessed it was pump. 5 hours over a period of 2 weeks
Ordered pump.
Replaced it.
Problem solved.
5 or so more hours. Most of work opening side panel
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frank from SPRING BRANCH, TX
- Parts Used:
- 00633707
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Front cover had a broken lense over the control panel. Upon replacement of the cover I broke the knob off. I would recommend that you purchase the knob instead of doing it twice like I did.
Power OFF. Move dryer away from the wall. Make sure the knob is in the "OFF' position. Remove screws (2) holding top cover from back of dryer. Remove "BOSCH" cover plate from left side of front cover. There is a screw here holding the cover to the frame. Gently pry cover away from framework, being careful not to damage the cover clips. Once away from the dryer, remove the plug from the board. You will need to remove the board from the back of the cover to gain access to the knob. Make sure the knob aligns with the "OFF" position before reassembly. Reverse the the instructions for reassembly.
Was this instruction helpful to you?
Thank you for voting!